Specifications:
- Rated Voltage: 90 - 450VAC, 50HZ / 60 HZ
- Single phase
- Maximum effective load limit: 40,000 Watts
- Withstands surges to 480 VAC
- Self-healing metallized capacitors
- UL Listed components
- Waste Disposal: Dispose of in accordance with all local, federal, and foreign regulations, Component liquid is bio safe
- NEMA 3 Waterproof casing
- Weather Resistant Indicator Light
- NYY-J cable, high quality double jacketed. Prevents damage and fire
Ships with:
1 x Intelliworks Energy Saver
1 x Product Manual
Connection Diagram:
Installation:
1. Before doing any installation of the power saver S200, make sure that the main breaker switch is in the OFF position. It will remain in the OFF position until the installation is complete.
2. Install a 20 amp breaker and secure the red wire of the S200 unit.
3. Next, secure the green wire from the S200 to the ground bar in your breaker panel.
4. Make sure that all wires are secure and that the S200 unit is secure. Turn your main breaker lever to "ON". Turn the 20 amp breaker to "ON" on the S200 unit. Make sure that the indicator light is on. If the light does not come on, turn off your main breaker and the breaker on the S200 unit and re-check all wires.
5. If your indicator light came on then you have successfully installed your S200 unit.